Jump to content
Ultimaker Community of 3D Printing Experts

Nozzle height


mastory
 Share

Recommended Posts

Posted · Nozzle height

So far in just less than 2 weeks of printing, I have only found only generalizations regarding how high the print nozzle should be when the Z axis is zeroed. This hasn't stopped me from making prints, but it has left some doubt as to what is optimal. I have been able to effectively level the bed and make prints with the height approx. .003-.008" (.08-.20mm). I have done this by using copy paper as a feeler gage either single or doubled over and adjusting the leveling screws or the switch to get an even drag resistance. I used my dial calipers to measure the paper. I think real feeler gages are in order. Have them in the garage, but not knowing what might be the ideal setting, it makes little difference.

I suppose it makes a difference what your bottom skin settings are, and which slicer is being used. Relative to that, I am asking how you set your nozzle clearance, what distance you set it to, and which slicer you're using.

I would hope that a series of rule of thumb standards could be established to take the guesswork out of the process.

Matt

  • Link to post
    Share on other sites

    Posted · Nozzle height

    For SF I would adjust the start code, for NetFabb you might be able to do the same. But SF also has the "bottom" plugin which might be able to do something with this. Not sure.

  • Link to post
    Share on other sites

    Posted · Nozzle height

    I use a feeler guage and adjust between 0.0 to 0.3mm when printing with High Quality style in Netfabb which is a 0.12mm layer height and 0.06mm half layer height for outer contours. I find if a print just doesn't start a couple of times in a row I adjust it down a small amount.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...