Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

I've just installed and calibrated the dual extrusion kit. It's all working perfectly for the first few layers but then it all goes wrong.

Looking at the filament it seems that after a few back/forward feeds from the extra retraction the teeth are causing the plastic to get 'fluffy', for lack of a better description, eventually leading it to just gouge out a groove and stop feeding altogether.

Cutting a short section out of the filament and switching back to a single material print and everythings fine again.

I know the extra retraction is to help with the oozing but I was wondering how everyone else is getting on? Have you changed the retraction amount? Loosened the feeder spring? Is it just the filament I'm using?

-Barry

 

  • Link to post
    Share on other sites

    Yea everything is working fine with regular retraction when printing with one nozzle. (in fact I think the act of taking it apart to install the kit has made it even better than it was before)

    When doing a dual material print both heads print well if I disable retraction (but oozing gets out of control and ruins the print), both heads eventually fail to feed if it's turned on at the default value in cura.

     

  • Link to post
    Share on other sites

    Retraction is set to 40mm/s, I presume that's the default as I cant remember changing it.

    I think I may have a better idea now. It stopped feeding again but as I was pulling out the jammed filament the bowden tube popped out too, a plug had formed at the end. The alu and bottom plates are at a bit of an angle, with the nozzle side being lower than the fan side. I think the bowden tube and white connector are not meeting flush, although I thought with the new hot end design the molten plastic wasn't supposed to get that far up.

    Could it be that the long retractions are pulling moltem material further up the tubes than you'd otherwise get?

    I'll take the whole carridge apart and see if I can get it aligned a bit better, maybe try a spacer on the fan side threaded rods to keep the middle and bottom plates a bit more squared up.

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker turns 10: A look back
        Ultimaker is turning 10 years old and that means it is story telling time! We'll explore 2010-2014, traveling through the evolution of the business from the Protobox and Ultimaker Original, to the major leaps forward with the Ultimaker 2 and Ultimaker 3.
          • Like
        • 0 replies
      • Ultimaker Transformation Summit
        Visit our virtual showroom and learn more about the Ultimaker ecosystem!
        • 14 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 4 replies
    ×
    ×
    • Create New...