Announcements
-
Our picks
-
The Ultimaker Showcase — October 14. What's new?
SandervG posted a topic in Official news,
Your dear friends at Ultimaker have some exciting news and insights for you!
-
- 0 replies
Picked By
SandervG, -
-
New here? Get ahead with a free onboarding course
SandervG posted a topic in Official news,
Hi,
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.-
-
- 8 replies
Picked By
SandervG, -
-
Recommended Posts
Torgeir 195
Hi 3D-Ya,
I know this question is about what is error 13 reported from Cura.
After some lurking around, I found this to be an old issue with Cura.
The Error 13 seems to mean; Access denied.
As there is a hi number of Cura versions, it will helps a lot if we new the version you are using and how this happen.
What do you do when this error occur?
Thanks
Torgeir
Link to post
Share on other sites