Jump to content
diek0038

first layer print not filling in correctly

Recommended Posts

Posted · first layer print not filling in correctly

*very new to printing*

Something went wrong within the last two weeks with the Cura software. I have been printing letters for felt letterboards and successfully got 2 sets printed before the letters started coming out wacky. The problem is on the first layer (the one everyone will see) and it's like its not filling it in properly. I am using two different Creality ender 3's and I have been leveling the bed in between prints so I don't think it's a machine problem. I have been trying to play around with settings in Cura but nothing I change is helping. I don't know which settings would even help this problem and which are irrelevant. What I was using and what was working before something went weird: PLA- bed temp 50, extruder temp 205. Print speed 60 mm/s, layer height 0.25mm, everything else was set at calculated.

IMG_1413.jpg

IMG_1415 2.jpg

IMG_728D0AC289C3-1.jpeg

Share this post


Link to post
Share on other sites
Posted · first layer print not filling in correctly

Very hard to say from the photos, but at first glance it looks like the first layer is rather thick. So, could it be that the nozzle is a bit too far away from the build-plate? My first layers look way thinner, and they are usually defined as 0.2mm.

 

PS: Beautiful letters by the way...

 

Share this post


Link to post
Share on other sites
Posted · first layer print not filling in correctly

Using Cura 4.0 with an ANET A8, uprated to Marlin.  I noticed the same problem on recent prints.  I was printing a 28 mm diam disk, 3 mm base thickness, using 0.2 mm layers (later 1.5 mm, but fault still present).  The part ended up 3.5 mm thick, with the lower side being a 1 mm disk of reduced diam (by 1.2 mm) and of much lower infill resolution than the rest of the layers.

 

I have recently performed a full levelling / alignment process, and am happy that the problem is not mechanical.  Material flow is smooth, temperatures at 200C (extruder) and 60C (bed).  The workpiece is sticking nicely to the bed. I can't see anything in the (Cura-produced) GCODE which is an obvious cause.

 

I have tried tinkering with the profile to see if there is an easy cause, but nothing obvious.

 

The only other clue is that the 3 mm base is supposed to have absolutely vertical edges, but examination shows the part growing in diameter slightly as each layer is printed.  By the time it reaches the top surface of the disk, it has crept up to 28.4 mm.

 

Does this sound familiar to anyone?

 

CIM 

QLS50b.stl

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!