Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up
Jbanner

Play a sound when prints complete?

Recommended Posts

Posted · Play a sound when prints complete?

Would it be possible to add in a future update the playback of a sound when printing completes?

 

Our S5 is in the other room, just around the corner, with the wall obstructing the view… 

So, it would be great if it could make a happy/friendly little beep (or some other kind of sound) when finished. 

 

This would make our lifes a whole lot easier so I ask you to consider it...

Share this post


Link to post
Share on other sites
Posted (edited) · Play a sound when prints complete?

I that should be possible via implementing a few lines of "sound" into the cura end code...

Did this also form my UMO...

 

Look here:

http://marlinfw.org/docs/gcode/M300.html

 

basically you can use every monotone ringtone in RTTTL format and this converter...
[ddrboxman.github.io]

 

or check if there are some available e.g. here...

http://www.picaxe.com/RTTTL-Ringtones-for-Tune-Command/

 

 

Edited by drayson

Share this post


Link to post
Share on other sites
Posted · Play a sound when prints complete?

Thanks for your reply, drayson 

 

I was hoping for more of an official solution which would mean less tinkering on my side...

 

Would be great if there was a factory option

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...