Jump to content
Jbanner

Play a sound when prints complete?

Recommended Posts

Posted · Play a sound when prints complete?

Would it be possible to add in a future update the playback of a sound when printing completes?

 

Our S5 is in the other room, just around the corner, with the wall obstructing the view… 

So, it would be great if it could make a happy/friendly little beep (or some other kind of sound) when finished. 

 

This would make our lifes a whole lot easier so I ask you to consider it...

Share this post


Link to post
Share on other sites
Posted (edited) · Play a sound when prints complete?

I that should be possible via implementing a few lines of "sound" into the cura end code...

Did this also form my UMO...

 

Look here:

http://marlinfw.org/docs/gcode/M300.html

 

basically you can use every monotone ringtone in RTTTL format and this converter...
[ddrboxman.github.io]

 

or check if there are some available e.g. here...

http://www.picaxe.com/RTTTL-Ringtones-for-Tune-Command/

 

 

Edited by drayson

Share this post


Link to post
Share on other sites
Posted · Play a sound when prints complete?

Thanks for your reply, drayson 

 

I was hoping for more of an official solution which would mean less tinkering on my side...

 

Would be great if there was a factory option

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!