Jump to content
Ultimaker Community of 3D Printing Experts

Print head assembly rods worn


davek17
 Share

Recommended Posts

Posted · Print head assembly rods worn

Hi There

 

We have been having a few issues with our UM3 which has meant we've been needing to unscrew the print head a lot. so the 4 long screws that pull the whole print head together with the hex tops are failing. The hex tops are just no longer biting the hex bits we have.

 

Can someone help me out with where we get these as I tried UM, our reseller and am drawing a blank.

 

Any help appreciated

 

 

  • Link to post
    Share on other sites

    Posted · Print head assembly rods worn

    Did you try contacting fbrc8.com?   They are U.S. based part supplier.  If they dont have it or can't get it, no one can.  They ship super fast.

     

    Last ditch effort would be to try McMaster-Carr, Fastenal, or Grainger.  Can determine the thread size with a thread checker or calipers, and then measure the shoulder length, thread length, etc to get the exact screw you need.

  • Link to post
    Share on other sites

    Posted · Print head assembly rods worn

    They are M3 screws (3mm - standard thread).  With "socket cap" screw heads (although any head type should work).  You can indeed measure the length and get similar ones (threading will probably run the length but that's fine).

     

  • Link to post
    Share on other sites

    Posted · Print head assembly rods worn

    Hey guys, sorry for delay in getting back to you.

     

    I'll go and try those places then. Sounds like I just have to hunt for a raw screw then. I was hoping there would be standard place someone else had bought them from before to make life a little easier. These ones on the UM3 seem to be very soft, the UM2 ones I have seem to wear much better?

     

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...