Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  

how does it work for you?

Recommended Posts

Ok, so i bought it, installed it, reloaded it, upgaded it and calibrated it. Tested original printhead to see if it was the same as before (I was getting some very nice prints) and so far all back to normal. So now what about the second printhead? now it all gets a bit confusing really, what with ''don't use this version of Cura use that version'' or ''use this slicer, even though the results aren't as good'' or ''what you want to do is write your own G-code and drop it in your firmware'' Now I understand it is ''experimental'' but to me that means calibration, temp, retraction speed, wipe tower etc not here it is you get it to work!

I will say that I have spent the last few days trying different things but so far no results worth mentioning... and I don't want to cloud anyones answer with the different configurations i have already tried (maybe I didn't do it right).

So, what is the simple ''no nonsense way that has had results'' way to get this to print a two colour print?

Is there a non official but it works Ultimaker answer? Daid??

Regards to you all


Share this post

Link to post
Share on other sites

I'll be testing and building a mac version tomorrow. I did a bunch of UI changes which I have to test. (Every single UI change needs to be tested at Mac, because random shit tends to break. Which is why the test versions are usually only for Windows. Sorry)


Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!