Jump to content
abusuioc

Something weird with my printer

Recommended Posts

Posted · Something weird with my printer

In last print job Ultimaker 2+ has shut down after 75% of printing, second time has stopped but with nozzle heated and last time after 1 hour again printer has shut down after 1 hour of printing.

Share this post


Link to post
Share on other sites
Posted · Something weird with my printer

Not an expert but I would guess some issue with the power supply or heater/pt100 sensor.

 

Can you try with another power supply? (Do you have more than one UM2 or can borrow one?)

 

For the heater and the PT100 temperature sensor you can check if they are ok by measuring there resistance with an ohm. Meter. The PT100 should be about 108 ohm at room temp, the heater I’m not sure but can check later if needed. And if you do the above you need to disconnect them from the main board, also check if the connectors are tight, if not this is probably already the issue...

 

 

Share this post


Link to post
Share on other sites
Posted · Something weird with my printer
1 minute ago, ultiarjan said:

Not an expert but I would guess some issue with the power supply or heater/pt100 sensor.

 

Can you try with another power supply? (Do you have more than one UM2 or can borrow one?)

 

For the heater and the PT100 temperature sensor you can check if they are ok by measuring there resistance with an ohm. Meter. The PT100 should be about 108 ohm at room temp, the heater I’m not sure but can check later if needed. And if you do the above you need to disconnect them from the main board, also check if the connectors are tight, if not this is probably already the issue...

 

 

Thanks for advise....unfortunately i cannot open/demount because is still under warranty.  Already i call the dealership. 

 

The only thing what i can do i will try different model to print. i tried 3rd times on same model and was stopped in same X/Y but different Z.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Survey: Understanding your workflow
      Interact with future concepts and aim to collect your feedback and opinion. In particular, if this would/could be a welcome addition to your 3D printing workflow. Interested?
      • 0 replies
    • Coronavirus: Let's do our part
      Through this post I would like to further explain what we are doing, and what you could be doing. 
      Our efforts consist of 2 layers. First; connect medical institutions and hospitals to (local) 3D Printing hubs to help them print parts of which a 3D model already exists. And second, contribute to design the necessary part and then have it printed via a (local) 3D printing hub. Experts are available from within Ultimaker and from within our network of 3D printing experts.
        • Like
      • 45 replies
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!