cura 4.1issue

[JohnCarson 0]

My Cura 4.1 seems to slice my File correctly, producing a .gcode File. I place the .gcode onto my SD Card from my PC. Now the problem starts. upon choosing the Fie to Slice by Cura 4.1 I note no Heating of the Bed. immediate the Ender 3 goes to Heating the Extruder to 205 degrees F. Once heated the Extruder does nothng in the 'z' direction.

 

1. I have installed to a Direct Drive Extruder and verified the print worked on an old File. 

 

Help, Please

[johnse 31]

I’m pretty new here myself and not experienced with gcode sleuthing, but you’ll probably get a better response if you post a Cura project (.3mf) file and the gcode file to your question.

[nallath 1,117]

Also, you posted this in the section for Ultimaker printers. The ender 3 is definitely not a printer made or supported by Ultimaker.