Jump to content
Ultimaker Community of 3D Printing Experts

I still get the ERRORS about LINES


Recommended Posts

Posted · I still get the ERRORS about LINES

There are many lines like this

echo:Unknown command: ""

Error:Line Number is not Last Line Number+1, Last Line: 3

echo:Active Extruder: 0

Error:Line Number is not Last Line Number+1, Last Line: 3

Error:Line Number is not Last Line Number+1, Last Line: 5

 

Any ideas please?

 

  • Link to post
    Share on other sites
    Posted · I still get the ERRORS about LINES

    Daid is saying they don't cause any problems. You can ignore them. Are you having another issue? Besides messages in the log?

     

    It caused every layer prints at different positons that cannot successfully printed 3d projects.

     

  • Link to post
    Share on other sites
    Posted · I still get the ERRORS about LINES

    It caused every layer prints at different positons that cannot successfully printed 3d projects.

     

    Please show a photograph. It sounds like maybe your pulley set screws aren't tight enough.

     

  • Link to post
    Share on other sites
    Posted · I still get the ERRORS about LINES

    Please show a photograph. It sounds like maybe your pulley set screws aren't tight enough.

     

    32298047_227039.jpg

     

  • Link to post
    Share on other sites
    Posted · I still get the ERRORS about LINES

    It looks like there's a problem with your image. Maybe the site doesn't allow hotlinking?

     

  • Link to post
    Share on other sites
    Posted · I still get the ERRORS about LINES

    To post an image, click on gallery in top left corner of this page, then after you have uploaded your picture(s), start a new posting and click on "my media" next to the smiley icon to insert any gallery picture.

     

  • Link to post
    Share on other sites
    Posted · I still get the ERRORS about LINES

    Looks like hotlinking was the issue. Here's the image deago tried to post.

    deagos image

     

  • Link to post
    Share on other sites
    Posted · I still get the ERRORS about LINES

    This looks like your pulleys are slipping. I'm not sure if it's X or Y axis - you should be able to tell that yourself.

    Once you know which axis it is, each axis has 6 pulleys (SIX! not 4). 4 of the pulleys have the longer black belts on them. 2 of the pulleys have the short belt (to the motor). Make sure ALL 6 pulleys have had their tiny little set screw tightened. Tighten this screw quite a bit. It should be very tight. Consider also marking the pulleys with a permanent pen and also the rods so you can see which one is slipping.

    Most likely it is one of the 2 pulleys on the short belt.

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...