Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Posted (edited) · Prime Tower Falling

Does anyone have problems with the prime tower falling for tall prints like in the following Joel Telling (3D Printing Nerd) vid? 

 

Like in the vid, the Cura team has improved the prime tower default settings as it will now do a brim if the print is using one.  However, I've still had problems with the tower falling.  With a brim, the tower usually cracks off at the 2nd layer. 

 

I've tried increasing the size of the tower and am now printing 40mm towers, and I've increased the number of tower walls (by increasing Prime Tower Minimum Volume) to 4 (2 for nozzle 1 and 2 for nozzle 2), and it still falls (see attached photo of a print where I tried to salvage it by gluing the tower back onto the print bed -- the tower had cracked off after only having printed about 2 inches!).  I could keep making the tower thicker, but it would be great to have a really thick wall at the bottom and have it gradually thin out towards the top.  Or some other idea that would stop this problem.  Thoughts?

Screen Shot 2019-07-11 at 10.20.38 AM.png

Edited by Fred804
fixed type of 'not' where it should have been 'now'
  • Link to post
    Share on other sites
    • 2 months later...
    Posted · Prime Tower Falling

    I have solved this by printing with a really broad brim to keep the tower from breaking loose from the bed and enlarging the size and volume of the tower to keep it from breaking.  It uses a bit more material and takes a bit longer but I rarely have prime tower failures even with tall, skinny objects on my UM3ext.

    water bottle holder.JPG

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...