Jump to content
Ultimaker Community of 3D Printing Experts

Object structure changes depending on the geometry, possibly Cura problem


musti
 Share

Recommended Posts

Posted · Object structure changes depending on the geometry, possibly Cura problem

Hi all,

I am using a home built ultimaker with E3D print head, using ABS from reprap.cc printing at 230deg with 10% infill and 2mm walls.

All the objects I am printing appear to have the following problem:

Surface finish is significantly degraded, some small gaps and blobs appear, when the object does not have a continuous circumference on the layer. As you can see on the very simple object shown in pictures, first 10mm of the object have a very nice finish, because the base is a solid rectangle, with a gap in one side when higher then 10mm. Having such a gap causes the beforementioned problem.

This is consistent with the geometry properties, is not random and appears with different spools of material.

Any ideas how to solve it?

print problem 1print problem 2print problem 3

 

  • Link to post
    Share on other sites

    Posted · Object structure changes depending on the geometry, possibly Cura problem

    There could be many things causing this and I'm not sure which it is, but a lot of the time you can get a better surface by slowing down.

    Try printing 1/2 speed you are printing now to see what happens. The bowden tube tends to store pressure like a spring. So when the print head slows down, and the extruder slows down at a corner, the printer tends to overextrude approaching the corner and underextrude just past the corner. So this is one possible cause.

    Another possibility is that even though you asked for 2mm walls, in certain areas with those holes running through the corners, Cura may have been confused about how to fit 5 passes around the holes and another 5 passes along the side. It usually handles this just fine - I've even asked for 100mm skin and it usually works fine. But still. Try another slicer. Possibly Cura 13.04 which has a completely different slicing engine (but mostly the same settings so there is almost no learning curve). Or kisslicer.

    Older Cura's here:

    http://software.ultimaker.com/old/

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...