Bonjour;
Enlever la plaque, la nettoyer à l'eau chaude et au produit vaisselle, la sécher, et la remettre en place.. ensuite, passer la surface à l'acétone pur ou à l'alcool isopropylique ou médical...
Refaire correctement la calibration du bed...
Normalement le PLA adhère sur la plaque propre et asséchée... pas besoin de colle...
- 3 months later...
Idem quand ça colle pas je nettoie la plaque totalement et souvent ça règle le soucis. Avec ou sans colle si la plaque n'est pas nickel ça joue direct sur l'adhérence.
DidierKlein 729
Pas faux et même parfois trop de colle ou laque ça fait une sorte de film ou ça n'adhère plus aussi bien...
Il me semble que tu pourrais aussi mettre le plateau un poil plus haut
-
Our picks
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 18 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
Release Notes: S-Line Firmware 8.3.0 (Latest)
Dustin posted a topic in Firmware,
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.-
-
- 0 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
jeanmi681 1
Petites photos pour illustrer le problème 😓
Link to post
Share on other sites