Jump to content
marcottt

may i have on same PC cura 4.0.0 and 4.2.1 ?

Recommended Posts

Posted · may i have on same PC cura 4.0.0 and 4.2.1 ?

Hi all, i have an installation of cura 4.0.0 fully working, no issue. I wanna check cura 4.2.1 .... can i install side to side on same pc the 2 versions ? 
i must be careful with some step ?

Share this post


Link to post
Share on other sites
Posted · may i have on same PC cura 4.0.0 and 4.2.1 ?

Yes, that works fine. Cura copies the whole user data folder when upgrading, but leaves the old one intact. So when you start 4.0 back up, all the data is still there.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!