Jump to content
Ultimaker Community of 3D Printing Experts

both print heads exceed expected values


jweiland1
 Share

Recommended Posts

Posted · both print heads exceed expected values

My active leveling fails every time.   I adjusted the plate height so that is at least 14 mm between the lowest nozzle and the glass plate.   When I got a manual level--- the plate boundary is still 14 mm.

Also in the right nozzle is lower than the left not sure that's a problem

 

  • Link to post
    Share on other sites

    Posted · both print heads exceed expected values

    Hi,

     

    assuming you use an UM3?

     

    The 14mm are needed not between the nozzle and the glass plate, but between the underside of the heat bed and the upper side of the build plattform (base plate).

    The distance nozzle - glass bed should be manual levelled using the calibration card.

     

    Regards

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...