Printing multiple small component in one go

[SiddharthTilala 0]

Hello!!

 

I saw that i can open multiple component in Cura, also sizes fits together ( no component looks grey in cura) in one bed. does that means it will print properly in reality afterwards? Also how much distance between each component should i keep?  I hope you could understand the situation i am talking about. 

 

BR,

Sid

[Framar 38]

What you see on the print bed in Cura what you get

[Job_van_gennip 23]

You can always check whether the printer will print correctly by looking at the preview tab. In this tab you see what the printer will do. You can however be relatively sure that yellow parts will just print.