Jump to content
Ultimaker Community of 3D Printing Experts

Filament far away from print head


Recommended Posts

Posted · Filament far away from print head

Hello,

i have massiv problems with the position of the filament after a shut down of the printer. First I thought it happens only after a quick abort. 

I print an object over night. In the morning the object is ready. I remove the object and clean the plate and switch off the printer. In the afternoon I start a new print. The printer heat up and starts bed leveling. I alway use the Prime blob to validate the material. But there is no material coming and the print start without material. After same second the material is coming. 

When I am fast enough to realize the problem I am able to push material manually about 10 cm into the core and everything works fine. The problem start after update to the new firmware.

I use:

Ultimaker S5

Firmware 5.4.6 20191001

Cura 4.3.0

 

  • Link to post
    Share on other sites
    Posted · Filament far away from print head

    Same for problem for myself and others, I was advised to contact your re-seller to flag up this issue as its the best way to

    get it dealt with. Hopefully will be sorted soon as its taken the Ultimaker "it just prints" feel away

  • Link to post
    Share on other sites
    Posted · Filament far away from print head

    It is a bug in the firmware 5.4.6 and since a few hours you should see a firmware update message on your printer to downgrade to 5.2.11. If not, check manually for a new firmware you will see that the printer reports 5.2.11 again as the new one to downgrade.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker Transformation Summit
        Visit our virtual showroom and learn more about the Ultimaker ecosystem!
        • 14 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    ×
    ×
    • Create New...