Jump to content
Ultimaker Community of 3D Printing Experts

Reducing Stringing is skeinpypy


Recommended Posts

Posted · Reducing Stringing is skeinpypy

Good morning Gentlemen and Ladies

Ive had my ultimaker for just a few days, and i am currently having much success with the quality of my prints using skeinpypy =)

However, my current method to avoid stringing, is Ive just set the rapids value is skeinpypy to 3000....im pretty sure this just maxes out to whatever the max is in marlin. It works quite well in that there is little or no stringing, but there are still really shit markes in the print at the point where the strings should be.

Can anyone suggest a better tactic

P.S i attempted to use the filament reverse thing and had very limited success

  • Link to post
    Share on other sites
    Posted · Reducing Stringing is skeinpypy

    Retraction/reversal is suppose to help against stringing even more. But a lower temperature also helps.

    The travel speed is limited by the "Max feed rate" in the firmware, which is 250mm/s on the default build. This is a bit conservative as 300mm/s can also be achieved if apply proper lubrication. You can change the limit on the fly with "M203 X300 Y300"

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...