Jump to content
Ultimaker Community of 3D Printing Experts

Cura 4.3 slice errors?

Recommended Posts

Posted · Cura 4.3 slice errors?

I created a item in sketchup 2016.   basically a 6"x8" rectangle 3/8" inch thick with four holes in each corner.   each hole was 1/4" deep.    exported the stl file to cura 4.3.   opened up the file in cura and the four holes were very apparent in the opening view.   

slice the file and in the resulting image, the holes were gone.    xray view showed the holes, but the holes on the surface did not appear.   thought maybe the view was incorrect....so printed it,  but the holes were never created with no evidence that any attempt was made to create the holes throughout the print.      Is there setting that would cause this or is this a slice error?

thanks   dave

PS.   have done this process with a similar image print using Cura 4.0, and everything including holes appeared in cura and the final print.  tried to print this new file with 4.0 and then updated to 4.3 and same thing occurred.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Create New...