Jump to content
Belezeebub

S5 Calibration

Recommended Posts

Posted · S5 Calibration

I know this is going to be a face palm stupid question but can I input numbers smaller then +/- .5 my S5 is off by maybe .1 I only seem to be able to adjust in .5 units

 

Share this post


Link to post
Share on other sites
Posted · S5 Calibration

Can you please be a little bit more specific and elaborate what you mean exactly? 

What do you want to adjust and where?

Share this post


Link to post
Share on other sites
Posted · S5 Calibration

When I replace my nozzles it will blather about this configuration is not calibrated, so I run the calibration (see attached) I can move the calibration in .5 increments but .1 would be much closer to what I need.

 

This one.JPG

Share this post


Link to post
Share on other sites
Posted · S5 Calibration

Ok got it 😀

And you cannot choose 3 or 12 for example? I haven't calibrated for a long time but as far as I remember I was able to choose any number from the sheet.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!