Jump to content
Ultimaker Community of 3D Printing Experts

Settings help


mark-hale
 Share

Recommended Posts

Posted · Settings help

Perimeters are the concentric loops around the outside of each layer of the print. These are basically the bits you see most of - the outside surface of the sides of the print. Some slicers allow you to specify the number of rings of plastic that you want - the instructions were asking you to set a single ring.

Cura measures that in terms of a distance, rather than a number of rings of plastic, and refers to it as the 'shell'. So to get a 'single perimeter' you need to specify a shell thickness equal to your nozzle size - usually 0.4mm on an Ultimaker. In general, you should always set the shell thickness to be an exact multiple of your nozzle size, so that Cura can easily and exactly use a whole number of adjacent passes to make the shell layer.

 

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...