Jump to content
Akashigiri

Why does my first layer print test look like this?

Recommended Posts

Posted · Why does my first layer print test look like this?

Hello,

after leveling my bed I tried a bed leveling test print of one layer and this came out. I don't know where the problem is. Is my nozzle clogged? If it is clogged than I don't know what to do. I have already clean my nozzle many times but it still keeps clogging.

20191116_001056.thumb.jpg.7d7090fc390164fe19ecdf20f4c7d603.jpg

Share this post


Link to post
Share on other sites
Posted · Why does my first layer print test look like this?

Ok i figured it out. It was under extrusion. The stock plastic extrudor was just bad. I replaced it with a aluminum one and everything was fixed!

Share this post


Link to post
Share on other sites
Posted · Why does my first layer print test look like this?

i had the same issue. same fix. now new troubles with cheap printers await.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!