Jump to content
Ultimaker Community of 3D Printing Experts

Issue with stringing


Recommended Posts

Posted · Issue with stringing

Printer U20 ONE (Gearbest)

Cura 4.3

HATCHBOX filament (brand new)

I'm a newbie, this is my first printer and tests. I noticed after printing benchy the stringing issue. I have lowered my temp to as low as 180 (bed at 60), I have played with my retraction distance (from 5 to 10mm) and my retraction speed from 40mm/s to up to 60mms/s with no success. I also have Z-hop checked on.

What else can I test? Could a different brand filament help?

I haven't updated the firmware from my u20, could that help?

FAKE EDIT - I just read a post saying that switching to CURA 4.1 could solve the issue... but I haven't tried yet.

Thanks in advance for your feedback.

2019-11-16 07.20.17.jpg

2019-11-16 07.20.30.jpg

2019-11-16 07.20.34.jpg

2019-11-16 07.20.40.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 13 replies
    • Create New...