Jump to content
Ultimaker Community of 3D Printing Experts

Infill is not sliced and printed every layer

Recommended Posts

Posted · Infill is not sliced and printed every layer

Just noticed after all my prints turns out to have very bad infill that cura 4.4 slices and prints all the infill with one "pause" layer(see attached picture). Is there a reason for this and how can i edit this so it prints support every layer? this really messes up all my prints where i need infill. Infill density is set to 1% and ive tried several other settings including pattern, line multiplier and thickness.


any tips or solution is greatly appreciated

Merknad 2019-11-23 185651.png

  • Link to post
    Share on other sites
    Posted · Infill is not sliced and printed every layer

    You're using zigzag infill pattern that prints alternate layers in different directions. Because the infill density is so low (you're using 1%) there's going to be a lot of air under each infill line. 1% gyroid infill does a better job (I think) but will still have problems at the top of the print where those rectangular skin areas are as they and the walls around them will be printed on air. You are going to need more infill to print those areas.





  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker Transformation Summit

        On April 20 - April 23 we will host the Ultimaker Transformation Summit. Come talk to us via Live chat and get inspired by any of our relevant presentations!
        • 5 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    • Create New...