Fingers are NOT supported by Cura

[Birdman2010 0]

Everyone,

 

This is an on-going issue!  How can we get the programmers for Cura involved?  Cura does not support fingers that point downward on the models.  I have attached TWO models that have fingers that point downward.  The fingers on BOTH models are not supported.  On both models, the fingers are printed in mid-air.  Please see the photo.

 

 

groot_w_stand.stlBabyyodaonbase.stl   

 

Please review this post:  

 

[burtoogle 509]

Set minimum support area to a suitably low value and it will support those fingers....

 

 

No need to involve programmers!

[Birdman2010 0]

Awesome!  I can't believe that it was that easy!  Thank you!