Jump to content
Ultimaker Community of 3D Printing Experts

skirt bug?


Dseven
 Share

Recommended Posts

So I used Cura 4.4.0 to slice https://www.thingiverse.com/thing:3057351 for my Ender-3 Pro (0.15mm, 10% infill, supports on), and was surprised when the object was printed over the skirt on one side! Not a big deal in this case - I snipped it off, and it's on the under-side, so not visible... but this seems like a bug? The skirt should go around the widest points on all sides of the object... ? (yeah, I have some calibration stuff to get dialed in too, but I don't think this is a calibration issue)

 

DSCF0944.JPG

  • Link to post
    Share on other sites

    The bug(s) are in the model. The skirt goes under the model because the base of the model is not flat. If you lower the model into the buildplate a tiny amount then the skirt goes around the whole model. The model also has other issues as you can see.

     

    Screenshot_2019-12-02_07-24-28.thumb.png.46759a25f8e16374f0bc6c657992772f.png

     

    Screenshot_2019-12-02_07-20-55.png.27fa78dc229edf5d312889a9718d5ab9.png

  • Link to post
    Share on other sites

    Posted · skirt bug?

    Hmm. I did notice that it was not flat on the bottom .. but it was close enough that the skirt became part of the object. Maybe the skirt should consider any overhanging areas that are within a certain elevation of the base? I accept that it's a buggy model, though - thanks!

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
         
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...