Hi
I have the same problem. The Air Gap is on both Material set to 0, but the support Material is not generated for the first Layer. I hope someone can help to solve this issue.
I have now seen that every second layer is missing. With the support structure for the part, however, every layer is printed. Where is the setting that every layer is printed on the prime tower for the support Material?
Cura 5.2.1
Edited by HFJuli
additional info
Recommended Posts
Curven 28
Hello I actually never printed with a raft. But as far as I know it is normal that there is a gap between the raft and the part, without it it would be impossible to remove the raft of the part...
I think I have read somewhere that this gap can be configured in Cura, but as I never used it I can not give an advice on the optimal gap. (between support and print the gap is 1 layer)
I looked in Cura and found that:
By default the gap is 0.3mm. I would try reducing it to 0.2 and then adjust if necessary,
Link to post
Share on other sites