Jump to content
Viggoman

Ultimaker 2, bed temp error issue

Recommended Posts

Posted · Ultimaker 2, bed temp error issue

I'm experiencing  a bed temp error message after e few minutes of printing. It seems to happen at more or less the same spot every time.

 

Recycling the power clears the error, but it repeats after a few minutes.

 

I have had a bed temp issue a few month back and followed the trouble shooting instructions, even replaced the main board. But it wasn't until I checked the wire connector at the bed it got solved.

 

I have tried this out again to no avail. 

 

Any tips tracing the culprit of this?

 

Thanks

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Survey: Understanding your workflow
      Interact with future concepts and aim to collect your feedback and opinion. In particular, if this would/could be a welcome addition to your 3D printing workflow. Interested?
      • 0 replies
    • Coronavirus: Let's do our part
      Through this post I would like to further explain what we are doing, and what you could be doing. 
      Our efforts consist of 2 layers. First; connect medical institutions and hospitals to (local) 3D Printing hubs to help them print parts of which a 3D model already exists. And second, contribute to design the necessary part and then have it printed via a (local) 3D printing hub. Experts are available from within Ultimaker and from within our network of 3D printing experts.
        • Like
      • 46 replies
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!