Jump to content
Ultimaker Community of 3D Printing Experts

Ultimaker | Release update


SandervG
 Share

Recommended Posts

Posted · Ultimaker | Release update

Hi, 

 

After careful deliberation we feel confident to lay out some guidelines in terms of planning and expectations which might be useful for everyone who has ordered an Ultimaker Pro Bundle or is planning to. 

The Ultimaker S5, Air manager, material station individually or combined as an Ultimaker S5 Pro Bundle are available with our sales partners and resellers. Due to a delay upon launch and a high demand there could be a lead time before it will actually be shipped. 

Please inquire with your local point of sales about any lead times they might have. 

Curious where you can buy an Ultimaker S5 Pro Bundle? Please visit this link for all available, resellers: https://ultimaker.com/resellers/

 

The firmware that unlocks all air filtering profiles, optimised for different materials for the Ultimaker Air manager has been released today (5.4.27). So you should be able to benefit from different fan speeds depending on which material you select, that also takes into account an optimal build volume temperature. 

Note: It is important to allow your Ultimaker to cool down after a print or after an operation that requires your Ultimaker to heat up a print core or heated bed temp above 50ºC. If you start a new print before it has cooled down below 50ºC, the fan speed will not yet be reset to your (possibly) newly selected material. So let it cool down first. This will be updated in an upcoming release. 

 

The Ultimaker material station is fully operational with our Ultimaker materials. The material profiles for the materials available via the marketplace are being updated by our material partners and will be gradually available throughout Q1 in 2020. If using a third party material is essential for you, this is still possible on a 'stand alone' Ultimaker S5 (+ Air manager). 

 

Hopefully this information is helpful for you. Please let me know if you have any questions, you can also reach out to me via a DM. Have a great day! 

 

 

  • Thanks 1
Link to post
Share on other sites

Posted · Ultimaker | Release update

Thanks for the update! Can we expect a blog post/forum post/etc. with a complete changelog for the 5.4.27 firmware update? I can't seem to find full documentation yet and was hoping to see if there was anything in it that might have fixed or adjusted the flow sensor errors people seem to have been getting on the last few firmware images for the S5.

  • Link to post
    Share on other sites

    • SandervG unpinned and pinned this topic
    • SandervG unpinned this topic

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...