Jump to content
Ultimaker Community of 3D Printing Experts

First Layer


zanggi
 Share

Recommended Posts

Hello,

I just started 3D printing and i have a problem...

When i started the printing session, the first layer looked like this. (Image attached)

Why does it look like crap? 😞

 

I use the Cura default Profile (0.2)

I only changed the infill and added support.

 

Send Help.

 

3D printer: Creality CR-10 max 

Bed temp: 60

Nozzle temp: 195

image.thumb.png.794f92da92642e3b316cf0218b47e991.png

 

  • Link to post
    Share on other sites


    Z offset is the devils work.

     

    It's the offset or the distance between the nozzle and the bed. 

     

    Different materials like to be squished (Tight offset as in the nozzle is very close to the bed) and some don't so the nozzle is further away, we are talking in like 0.1 MM increments or even smaller when adjusting it but it can be the difference between prints sticking and floating around on the bed.

     

    I've had off problems that by bringing the nozzle closer to the bed, it fixed it. Especially bed adhesion on glass, if the plastic is cooled before it hits the plate, it don't stick much. So by bringing it closer, it kind of squishes it a little bit which makes it much better

    • Thanks 1
    Link to post
    Share on other sites

    Posted · First Layer

    Oh okay, thank you for the explanation 🙂

  • Link to post
    Share on other sites

    No problem.

     

    Stick around here if you are new to 3D printing. I started about 2 months ago and being able to ask all the stupid questions rather than working them out makes all the difference. 

     

    I went through a lot of problems and I still get some but it's much better with the help of everyone on here.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
        • 11 replies
    ×
    ×
    • Create New...