Jump to content
Ultimaker Community of 3D Printing Experts

UM 2go remove z cap?


malin
 Share

Recommended Posts

Posted · UM 2go remove z cap?

Hi! I'm getting consistent horizontal banding at a specific location in every print on my UM 2go, and suspect the problem may be with the bearings or z-nut (I cleaned and lubricated the z screw to no avail). But, I can't figure out how to remove the z cap? The assembly manual for UM2 shows z cap screws underneath the build plate, but I don't find these screws on the UM 2go. How do I remove the z cap? Grateful for any help, or pointer to an assembly manual for the UM 2go!

  • Link to post
    Share on other sites

    Posted · UM 2go remove z cap?

    They are underneath the build plate. You have to move the bed up and then you can reach the 4 screws (around the z screw)  with a small tool. It is not so easy due to the limited space, but it is possible.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
        • 11 replies
    ×
    ×
    • Create New...