Jump to content
Ultimaker Community of 3D Printing Experts

Adjusting feeder with material change S5


Recommended Posts

Posted · Adjusting feeder with material change S5

Is it normal that I have to play with the adjustment of the feeder every time I change a spool of the same filament? Once again today I was replacing a spool of pla that was printing fine with a spool of the same pla. When it went to load it extruded a bit and I confirmed and began a print and no filament came out. I checked the filament and it had been ground down. I had to lessen the tension to get the filament to extrude. My concern is that I have a material station coming and I’m not sure it will work if I have to play with the tension every time a new roll loads.

  • Link to post
    Share on other sites
    Posted · Adjusting feeder with material change S5

    I have the s5 with the material station and I keep my feeder tension at half way and print an aray of material.  I have had a small chunk of filament break off during material change and lodge in the feeder, I had to pull the cover off and remove it.  If your feeder is too tight, which I have done, that will cause problems as well.  I also had an issue with the material station where the filament wouldnt reach the nozzle and that turned out to be a bad bowden tube.  You may want to clean your nozzle as well, cleaning filament works great for that.

    The material station is pretty slick I will say.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker turns 10: A look back
        Ultimaker is turning 10 years old and that means it is story telling time! We'll explore 2010-2014, traveling through the evolution of the business from the Protobox and Ultimaker Original, to the major leaps forward with the Ultimaker 2 and Ultimaker 3.
          • Like
        • 0 replies
      • Ultimaker Transformation Summit
        Visit our virtual showroom and learn more about the Ultimaker ecosystem!
        • 14 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 4 replies
    ×
    ×
    • Create New...