Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
jon_in_glasgow

Z axis motor off-line and looking for troubleshooting tips

Recommended Posts

First time post.... in the Maklab in Glasgow we have an Ulitimaker ~1 year old which has been doing good prints for lots of folk and this week the Z axis has gone dead for prints. The X and Y are ok, the extruder works. No visible faults with the Ulti-controller and have attempted print with a previously working g-code. During attempt at printing the Z axis motor is inactive and can be turned by hand - not a good sign.

I turned the Ulitmaker over and checked that the connectors and wires to the Z were seated. An initial google did not yield ideas and I did not find anything yet on the forum....

What to do next?

What checks can be done?

What kit and skills would be good to have?

Suggestions welcome - we want to get our beastie back up and running!

-Jon Hand in Glasgow

 

Share this post


Link to post
Share on other sites

http://reprap.org/wiki/Ultimaker%27s_v1.5.7_PCB

 

In the photo of the board on the bottom of the UM, there are these 5 "stepper driver" boards that can be removed without any soldering. They are socketed. The top right one is the Z driver (notice it is closest to the connector to the Z motor).

A quick check is to swap the cables for Y and Z. Use pronterface to move the motors 1mm at a time. If the problem is with the stepper motor or the cable the problem will stay with the same stepper (it won't move).

If the problem moves to the other stepper than it's something on this circuit board so next you swap the stepper drivers aka pololu's. These are manufactured and sold both by Ultimaker or through the rep rap community. If it's not the pololu (that's the most likely thing after cabling) then it's probably the arduino (even easier and cheaper to locate and purchase!).

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • How to 3D print with reinforced engineering materials
      Ultimaker is hosting a webinar where we explain how you can achieve and maintain a high print success rate using these new reinforced engineering materials. Learn from Ultimaker's Product Manager of Materials and top chemical engineer Bart van As how you can take your 3D printing to that next level.
      • 2 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!