Jump to content
Tarkahn

Overhang at the bottom of the print

Recommended Posts

Posted · Overhang at the bottom of the print

I've included picture.  After I installed the newest version of Cura (4.4.1)  I now get an overhang at the bottom layer where it should be flat with the build-plate.  This has never been an issue until I just today installed the newest version.  I assumed the print would automatically touch the buildplate - Is there a trick to getting this back the way it used to be?

 

You can see from the image that I'm testing this out by printing some flat plates - I've searched the forums but have not been able to find an answer to this specific problem.

 

I'm printing with an Ultimaker 2

 

Thanks for any help - I appreciate it very much!

Capture.PNG

Share this post


Link to post
Share on other sites
Posted · Overhang at the bottom of the print

Update:  As a test I installed a prior version and unfortunately the overhang on the bottom layer persists.  grrrr

Share this post


Link to post
Share on other sites
Posted · Overhang at the bottom of the print

I have also attemted to update the firmware on my ultimaker 2 - it is now version 3.3.0

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!