Jump to content

Strange brim issue, reinstall fixed

Recommended Posts

Posted · Strange brim issue, reinstall fixed

I had a strange issue where Cura wouldn't load (hung at loading profile).  Third try it loaded.  But then my petg print kept extruding fine on the part and first two lines of brim, but all brim lines after the first two were under extruded by about 50%.  Part kept warping up since brim was not well attached.  I was printing fine the day before.  I tried all kinds of levelling etc but it just wasn't working.  Then I remembered the cura hang at loading profiles.  I uninstalled cura, reinstalled, then typed my settings back in and it started printing fine.  All brim lines extruded correctly (no levelling between reinstalling cura).  I wish I saved the gcode output to compare... I kept saving to sd card and wiping.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!