Dual Nozzle Printing

[Mubha_Rocking 0]

Hi 3D Printing folks, Got an issue while Printing with Dual nozzle(Chimera type)

 

Whenever i am printing dual colored prints in PLA at 190-220 degrees on both nozzles with prime tower using 4.5-6.5mm retraction settings still the oozing is high. Have tried with different temp & Retraction settings.

 

The first hot end is passing through the print and then going to the prime tower, forming to ooze more, Can some help me how to bring the hot end directly to prime tower with out halting over the Printing part? 

 

Have tried with few G-Codes, Please let me know what can be done, Thanks in Advance !!

[ahoeben 1,850]

Have you tried printing at a lower temperature? Lower temperatures normally cause less stringing.

[Mubha_Rocking 0]

@ahoeben, Yes i have tried already with various temp & retraction settings also, can u suggest any G-code where i can get my hot end nozzles redirect to prime tower instead of passing through the printable part, Thanks in advance.