Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up
Link

Scratches in linear rods

Recommended Posts

Posted (edited) · Scratches in linear rods

 

 i have noticed the 10mm rods on my S5 have slight scratches in them. If i run my nail over them i can feel they are actually grooved slightly into the rod. I thought these were hardened rods ?, anyone else noticed this, they aren't particularly deep at moment but still i wasn't expecting to see any marks on them, maybe i just never noticed them on my 2+. I always keep the rods well oiled with the supplied thin oil.

 

20200404_073151.thumb.jpg.751f34924c1505a4c8007e74d557f31e.jpg

Edited by Link

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Essentials
      Ultimaker Essentials is an enterprise-grade package of Ultimaker software products with greater stability, uniformity, and a higher level of security. 
      • 0 replies
    • Cura settings: Improving naming and descriptions
      - Maybe you'd like to see more detailed descriptions for each setting?
      - Maybe you'd like to see some settings in a different category?
      - Maybe you'd like to see a completely new category?
       
      Give us your feedback in this thread and we'll consider it for future releases.
        • Like
      • 5 replies
×
×
  • Create New...