I just bought a lightly used UM2 from a fellow community member (it has ~28 hours on it only, so like-new). I printed the MiniCalTest file that was on the factory card. I am not sure how I am supposed to interpret the test results? I see some stringing and for the wedge, I don't know what that's about.
Pictured below, please advise and is there any thing I can tune?
Hi Nighthowler, thank you for your message and welcome to the community!
Happy to hear you found an Ultimaker.
The top minical test doesn't look too bad. You can see some stringing in between the pillars which could be something for you to look into to improve. This minical gives you an opportunity to see if your belts are tight enough (sharp corners), if your cooling is working (stringing, molten layers), and if your extrusion is on par. And it could show some other artefacts