Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up
Nafi

Introduction of the gradual porosity

Recommended Posts

Posted (edited) · Introduction of the gradual porosity

Dear Ultimaker Community!

 

I am quite a new user of the Ultimaker S5. I would like to print a gradually porous structure (20x20x20cm cube) with a 0.36; 0.38 and 0.40 mm gradual pore sizes.  In CURA I noticed one can fill in the 'gradual infill steps', but I don't seem to be able to find out how to put all of the desired pore sizes into the software.  I can only specify one 'infill line distance' value. Any help from more advanced users on how to fix this in CURA will be much appreciated!

Edited by Nafi

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...