SOLVED Problem with a GCode file

[Masterchief1863 0]

So I have this Gcode file that won't read on my Ender 5 plus. I have downloaded it and sliced it but it won't read on my printer. I have tried redoing the whole process but it still wont work. Here's a video of me slicing it and putting it into my printer. But the file doesn't pop up when it's in my printer. 

20200416_155801.zip

[ahoeben 2,047]

Do you perhaps have another removable drive on your computer?

[GregValiant 1,492]

Try shortening the file name.  Sometimes a long filename will cause problems when the printer converts the name to DOS 8.3 format internally. 

[Masterchief1863 0]

I just went and made the file name smaller and it actually popped up this time. So thanks guys for all you help.

[adieuk 0]

thank you guys i was going to ask the same question

[Mari 38]

When changing/inserting Mirco-SD card, use the "change SD-Card" option to read the content of the SD-card that is present!

 

Long filenames can be a problem, so keep them as short as possible (like the suggested DOS 8.3 format).  When a filename starts with "_" (underscore) this file will not show up on the printer... (found that out bij accident).