Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up
delir66

Hot head stays where the last printing point

Recommended Posts

Posted · Hot head stays where the last printing point

Hi there, I bought my first 3d printer weeks ago. Sincerelly, with Cura 4.5 everything is been so easy, working really good until now. 

 

I've been feeding the printer with an sd card lately instead of using the conection with the computer. Everything working good.

 

Suddenly, since two days ago, I does something really anoying. Instead of finishing the print and separating the x and z axis from the piece, It will move the x axis for a couple of cm and then come back to the last printing position. If i unattend the printer, when I'm back and the hothead is cold, the noozle is just attached to the printed piece. I have to warm up, separate it and then take out the piece. 

 

The thing is that I didn't make any change to my cura settings. No changes on the printer firmware.... Why this sudden change?

 

Everything else is just running fine. But this ending thing

I'm attaching a g-code file from this simple project (square rectangle, no bottom no top, only walls) 10mm high.

Maybe someone could take a look and tell me if the last lines correspond to the behaviour I'm commenting in here.

 

On the other side. I'm courious about G-code. I can't find the Z letter, instead the E letter appears always on coordinate strings. Does the E letter correspond to the Y axis movement?

 

Thanks a lot. 

 

GA_40x 80.gcode

Share this post


Link to post
Share on other sites
Posted · Hot head stays where the last printing point

Looking at your gcode, I see this sequence at the end...

;TIME_ELAPSED:3303.171209
G1 F2100 E3811.3849
M140 S0
M107
G91
G1 E-1
G0 X0 Y200
M104 S0
G90
G92 E0
M140 S0
M84
M104 S0
M140 S0
M84
M82 ;absolute extrusion mode
M104 S0
;End of Gcode

The G91 is setting the X/Y moves to relative and so the following G0 X0 Y200 may well be asking for a move off the build plate. Furthermore, the G1 E-1 is not going to work right either as the extruder is still in absolute mode. Perhaps you should have M83 rather than G91 ?

Share this post


Link to post
Share on other sites
Posted · Hot head stays where the last printing point

Thanks burtoogle.  Sorry, I'm not familiar with g-code, so I'm not alble to jujdje. 

I realised this is happenings since i'm printing in upper right corner of the plate (everywhere else scratched).  I would have thought that just happened twice by chance, but since it's not bringing z up after printing, i think is a bad behaviour. Cura should at least bring Z axis up at the end of the print. Specially if it's going to move Y (plate) and keep X still.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...