Jump to content

[feature request] Avoid only supports when travelling


Recommended Posts

Posted · [feature request] Avoid only supports when travelling

Hi there,


there's some useful feature that I don't use as often as I'd like to.


In the "travel" section we can find "avoid supports when travelling"; but I can only use this feature when also "avoid printed parts when travelling" is enabled, which I try not to use most of the time. It's also dependent on combing which I also want to disable in that context.


There are models and materials where I try to keep travel moves as short as possible due to oozing/stringing (therefore z-hop is no alternative) but this always comes with an increased risk of knocking over thin support structures. Which is not nice.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    • Create New...