Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Posted (edited) · Tough Pla

Hi Guys

i was wondering if somebody could help, I have a print that has been sliced using Ultimaker Tough PLA i have run out of filament half way through the print Can i load generic PLA or generic tough pla to finish the print or will it not work due to the fact that it has been sliced with the original product if it can be done how do i go about doing it?

 

Second question My BB.4 head with natural PVa that i use for support constantly thinks i am out of filament it seems that perhaps it is getting stuck in the feed because when i remove it it looks like the feed roller has chewed it out a little bit what is causing this and how do i stop it?

Edited by roccop
  • Link to post
    Share on other sites
    Posted · Tough Pla

    Hi

    Regarding your first question, I guess you have the possibility to override the material when you load it. But I am not sure, have never tried it myself. But keep in mind that you should take a material which is close to the UM ToughPLA, otherwise your object is maybe not strong enough.

     

    The PVA problem is 99% a problem of humidity and that your PVA has absorbed too much moisture. You should always keep the spool in a drybox or airtight bag when not printing and if you print a long job you should also consider to buy a Polybox or something like that, to keep the spool dry also during printing. PVA is very sensitive against high humidity and gets soft very quickly.

     

    But you can save your PVA spool and dry it again. Put the spool on the heated bead, cover it with a towel or cardbox and leave it there over night.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker turns 10: A look back
        Ultimaker is turning 10 years old and that means it is story telling time! We'll explore 2010-2014, traveling through the evolution of the business from the Protobox and Ultimaker Original, to the major leaps forward with the Ultimaker 2 and Ultimaker 3.
          • Like
        • 0 replies
      • Ultimaker Transformation Summit
        Visit our virtual showroom and learn more about the Ultimaker ecosystem!
        • 14 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 4 replies
    ×
    ×
    • Create New...