Jump to content
Ultimaker Community of 3D Printing Experts

I am a beginner and need some major pointers...


Recommended Posts

Posted · I am a beginner and need some major pointers...

I have been reading around and trying different things but I am so overwhelmed I have no idea what the issue is. I am using and Ender 3 Pro and need a lot of guidance. The print is very bad, and even didn't fully print to the top. It was a normal stringing benchmark and clearly does not pass. Anything is helpful thank you for your time.

116016321_734716877365617_3179161878767632624_n.jpg

  • Link to post
    Share on other sites
    Posted · I am a beginner and need some major pointers...

    Hi, @grouchyxd welcome to the forum.

     

    It can be overwhelming at the beginning for your first prints but I'm sure you'll get the hang of it quickly. 

     

    What your trying to print is very small which makes it a bit more difficult. 

    You may want to start off with something a bit bigger which will be easier till you get the hang of it. 

    It looks like this print is a bit hot and you may want to reduce the nozzle temp.

     

    Can you post the material and settings you used?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...