Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up
Ludmasson76

Ultimaker 3 doesnt print fully on some Z layers.

Recommended Posts

Posted (edited) · Ultimaker 3 doesnt print fully on some Z layers.

So I have been having a problem with the Ultimaker not printing fully on some of the Z layers. I literally have tried everything that I could find info on for Z related problems. I have cleaned the Z lead screw and bearings, I have cleaning out the motor that pulls the filaments, I have tried slowing down the feed rate of extrusion, I have check all belts. I have tried different models and different filaments. I am lost and cannot figure out how to fix this issue. With printing the same model it happens in different Z locations

 

With the picture provided, it will print perfect then all of a sudden not full print out  Z layers, then it will go back to printing good and then back to missing Z info. 

 

Does anyone have any advice or have dealt with this problem.

 

Thanks

Jasper

 

20200806_141056.thumb.jpg.66325a4978d64c5d5754196eb0b18137.jpg

 

 

Edited by Ludmasson76

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Talking additive | The 3D printing podcast
      Why should we be the only ones asking questions? Join us and ask Jabil all your questions on September 22nd 5pm CET
        • Like
      • 2 replies
    • Ultimaker masterclass: Optimizing your Ultimaker Cura workflow
      Save your seat for either broadcast on September 23.
      What will you learn?
      · Best practices for iterative print preparation and every lesson you should learn from each print
      · The right way to use per-object settings and when they are most useful
      · Easy-to-use resources for anyone who wants to develop their own printer definitions, plugins, or print profiles
      · How to optimize print profile settings and whether to “keep” or “discard” changes
      · When is the right time to export your drawing from CAD? (Based on Ultimaker Cura’s surprising power as 3D control software)
      · And a whole lot more tips and tricks!
       
      How can I join?
      This free masterclass will take place twice:
      1. 11am CEST (5pm SGT, 5am EDT)
      2. 5pm CEST (11am EDT, 8am PDT, 11pm SGT)
        • Like
      • 0 replies
    • Do you use 3D printing at work? Let us know
      It doesn't matter if you are using 1 Ultimaker or 10, there is inspiration in everything. We're looking for ...
      • 1 reply
×
×
  • Create New...