Jump to content
Ultimaker Community of 3D Printing Experts

may a defective side fan be the issue?


Recommended Posts

Posted (edited) · may a defective side fan be the issue?

I am getting very frequent tPLA underextrusion on my S5, resulting in halted prints (if the flow sensor is on) or ruined print (if the flow sensor is off). I have replaced both the prinhead and the bowden tube, and I have cleaned the feeder many times. None of this has resolved the issue.

Now I have noticed that the part of the filament entering the upper part of the printhead has an increased diameter, suggesting that it was partially molten. I think that this may indicate that the temperature creeps up from the nozzle to the upper metal tube. If true, this might indicate that the side fan is not working. But it's difficult to see the fins of the side fan, even with a flashlight. Is there a way to test the functionality of the side fans?

 

 

image.thumb.png.ad4e4e648d4b47aa4585a55d108f4941.png

 

Edited by aag
  • Link to post
    Share on other sites
    Posted · may a defective side fan be the issue?

    I am seeing the exact same thing on an Ultimaker 3. It was printing beautifully and then suddenly started jamming. I did all the same thing you listed, new tubes, new print core, cleaned the feeder multiple times only to have it repeatedly fail. Eventually I noticed the same thickness of the filament as your photo. I just logged in to see if there was a suggested solution for this.  I’m going to replace the front fan and will update after testing. 

  • Link to post
    Share on other sites
    Posted · may a defective side fan be the issue?

    In my case it turns out it was a failing front fan. It was still revolving, but at a lower speed insufficient to cool the printheads.

  • Link to post
    Share on other sites
    Posted · may a defective side fan be the issue?

    Agreed! Some little strings of filament can get caught up in there and make it stop spinning, or spin too slow. It is also possible that by an unfortunate event that the cables got pinched somewhere. But usually it is some debris in between the blades.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...