Jump to content
Ultimaker Community of 3D Printing Experts

e3d v6 upgrade Firmware problems


Recommended Posts

Posted (edited) · e3d v6 upgrade Firmware problems

I have upgraded my ultimaker2E with an e3d 6v hotend as well as a titan extruder to make the system a direct drive. Everything appears to be wired correctly, but there seem to be issues with the firmware in regards to the temperature sensor. I have measured the resistance of the thermistor as well as the heat cartridge, and both have values well within their tech specs, so the issue is not likely to be a hardware issue. 

 

The problem I am coming across is that whenever I try to do any heat up process, whether it be printing or changing material, the printer appears to take over 5 minutes to heat up according to the progress bar on the display. After about 5 or 6 minutes, maybe a bit more, i get an E03 error, which is a heater error. I have modified the firmware using the following two lines from the e3d tutorial https://wiki.e3d-online.com/E3D-v6_on_Ultimaker_2#Firmware_Changes 

#define MAX_HEATING_TEMPERATURE_INCREASE 0.1 //[E3D] original value 10
#define MAX_HEATING_CHECK_MILLIS (90000) //[E3D] original value(30 * 1000)

unfortunately, this has not apparently helped, and I am not sure where to go from here. 

Edited by Plushberry
  • Link to post
    Share on other sites

    Posted · e3d v6 upgrade Firmware problems

    I think you can't plug a thermistor into the normal temperature input of UM2 mainboard, because it's designed for PT100 elements. That's why the upgrade kit from your link came with a PT100 sensor.

    How have you connected the thermistor from the E3D hotend? And does the firmware reports reasonable temperature values?

  • Link to post
    Share on other sites

    Posted (edited) · e3d v6 upgrade Firmware problems

    i also used this page to change the temp sensor definitions, though I have noticed that there are three temp sensors defined. (and i am not sure what the third one is there for, i only have one hotend, not two) https://wiki.e3d-online.com/E3D-v6_Assembly

     

    I think this is likely where the issue is stemming from, unless there are other methods to determine the source of the issue. 

    Screen Shot 2020-09-04 at 6.52.17 AM.png

    Edited by Plushberry
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
         
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...