Jump to content
Ultimaker Community of 3D Printing Experts

Interface layers and support removal.


Recommended Posts

Posted · Interface layers and support removal.

I’ve been learning cura at a slow rate.  I was doing fine with easily removed support structures.  Apparently, in my exploring, I changed something and now support is very hard to remove.  I think this may have something to due with interface layers but not sure what I need to change and to what value.

 

i need help understanding what might have caused a change in the ability to remove support.

  • Link to post
    Share on other sites
    Posted · Interface layers and support removal.

    I don't know the answer.  Just raising the temperature a bit will make the printer extrude a few % more and now support will bond more with the part.

     

    1) There is a setting "support z distance".  That is probably the crucial one.  Make sure it is equal (or larger) to your layer height.  If your layer height is 0.1 then support distance of 0.15 and 0.19 will not do anything different.  But 0.2 will be more than 0.1.  I very very rarely use support so I'm not an expert and not sure what 0.2 z distance means for 0.2 layer height - is it the very next layer?  Or the layer after?  You can ask cura by setting it to each possibility and checking if there is a "blank" layer in preview mode.

     

    2) You can see what settings you have changed in cura from the default profile.  At the top of the settings there is a box next to the word "Profile".  In that box it should say "fine 0.1" or "fast 0.2" or similar.  On the right side there is a star (if you have made changes).  Click that star.  In the box that pops up on the lower right look for settings that are crossed out (it means you overrode that setting with the value in the "current" column).  And look for settings that are italic.  Also click on the tab above that: "Extruder 1" and check those settings.  This shows you what you have overridden in the profile.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...