Is CURA associated with Solidworks?

[ram1009 0]

I just tried to open Cura for the first time and it insists on trying to activate an old installation of Solidworks.  Why???

[nallath 1,117]

Probably because you have the solidworks plugin installed.

[ram1009 0]

On 9/18/2020 at 2:13 AM, nallath said:

Probably because you have the solidworks plugin installed.

I haven't installed anything.  I haven't even run Cura yet.  Does Cura install SW plugin by default during installation?  Do you know how I can get the program to open?  Right now, Cura halts to allow the SW install manager to verify my SW license (which is no longer valid) and when I dismiss the SW manager Cura does not progress.  I've already uninstalled SW using Ccleaner & did a registry cleanup but obviously a remnant remains.  Any suggestions?EDIT:  This program has given me nothing but grief.  After a lot of work I managed to re-install V4.7.0 and openit whereupon I was told to download V4.7.1.  Which produced so many errors while installing that it was not possible to complete.  Goodbye Cura.

Edited September 19, 2020 by ram1009